Need McKeon Door rolling steel door repair in New Hampshire? We diagnose the problem, give you a price before any work starts, and finish most jobs in a single visit. Rolling steel service doors, curtains, guides and springs repaired. Our technicians service McKeon Door commercial doors regularly and know where the model and date labels are, which makes ordering the right part quicker. McKeon makes rolling fire doors, fire curtains and rolling steel doors.
Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.
When to call for McKeon Door rolling steel door repair
- The curtain is jammed or crooked in the guides
- Bent slats or bottom bar
- The door is hard to raise by hand or chain
- The operator runs but the door doesn't move
What usually causes it
- Impact damage to slats or guides
- Loss of spring tension in the barrel
- Worn operator components
What you can check yourself
- Don't keep forcing a jammed curtain.
- Look for bent guides near the floor.
Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.
What happens during the visit
- Inspect the curtain, guides, barrel and operator
- Replace damaged slats or the bottom bar
- Adjust the spring tension in the barrel
- Repair the operator
- Test the full travel
How much does McKeon Door rolling steel door repair cost?
What moves the price:
- Door size, gauge and cycle rating
- Operator type and controls
- Parts availability for your model
- Lift equipment and after-hours access
These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.
Other McKeon Door services
Serving New Hampshire and nearby towns
Road salt and meltwater dripping off vehicles rust the bottom of tracks, cables and roller stems, which is why cable and roller failures in New Hampshire usually start at floor level.
Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.
We cover 110 cities and towns across New Hampshire. Find McKeon Door rolling steel door repair in your city:
McKeon Door Rolling Steel Door Repair: frequently asked questions
How much does McKeon Door rolling steel door repair cost in New Hampshire?
McKeon Door Rolling Steel Door Repair typically costs $300-$1,500 including parts and labor, and usually takes 2-4 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.
Can you do McKeon Door rolling steel door repair the same day?
Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.
Is McKeon Door rolling steel door repair covered by a warranty?
Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and McKeon Door warranty terms vary by product and age. Ask for the warranty details in writing with your quote.
Are your technicians licensed and insured?
Our technicians are insured, and where New Hampshire or your city requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.
Should I repair or replace my commercial door?
A good rule of thumb: if the repair costs more than about 50% of a replacement, or the commercial door is near the end of its life, replace it. Commercial doors are rated by cycles. If the door has reached its rated cycle life, has several damaged sections, or parts are no longer made, replacing it is often cheaper over the next few years. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.