Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving all of New Hampshire

Broken Garage Door Spring Repair in New Hampshire

Fast replacement of broken torsion or extension springs, sized to your door's weight. Typical cost $200-$450.

When your door needs broken garage door spring repair, you want it done safely and right the first time. Typical jobs in New Hampshire cost $200-$450, and you approve the price first. Fast replacement of broken torsion or extension springs, sized to your door's weight.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

Signs you need broken garage door spring repair

  • A loud bang from the garage, like a gunshot
  • A visible gap in the coils of the spring above the door
  • The door feels extremely heavy or won't lift more than a few inches
  • The opener strains, hums or the door reverses right away
  • Cables hanging loose from the drums

Common causes

  • Springs reaching the end of their cycle life (usually about 10,000 cycles)
  • Rust on the coils, which adds friction and stress
  • Springs that were the wrong size for the door
  • Cold weather making worn steel more brittle

Before the technician arrives

  • Don't use the opener. It can strip gears or pull the door off track.
  • Don't try to lift the door by hand. Without a working spring it may weigh 130 to 250 pounds or more.
  • Look, but don't touch: a broken torsion spring shows a clear gap in the coils.
  • Keep the door closed and keep children and pets away from it.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

What happens during the visit

  1. Secure the door and safely unwind any remaining spring tension
  2. Weigh and measure the door to size the new springs correctly
  3. Install new springs (we recommend replacing both on a two-spring door)
  4. Wind, set and balance the door so it stays put halfway up
  5. Test the opener's force and auto-reverse settings

Broken Garage Door Spring Repair cost in New Hampshire

$200-$450Typical range, parts & labor
1-2 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Local broken garage door spring repair for New Hampshire

In New Hampshire, spring failures spike during cold snaps, when worn steel is at its most brittle. If your springs are near the end of their cycle life, replacing them before winter is cheaper than an emergency call on the coldest morning of the year.

Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.

We cover 110 cities and towns across New Hampshire. Find broken garage door spring repair in your city:

Broken Garage Door Spring Repair: frequently asked questions

How much does broken garage door spring repair cost in New Hampshire?

Broken Garage Door Spring Repair typically costs $200-$450 including parts and labor, and usually takes 1-2 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do broken garage door spring repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is broken garage door spring repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where New Hampshire or your city requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in New Hampshire

Raynor Rolling Steel Door Repair

Rolling steel service doors, curtains, guides and springs repaired.

Typical $300-$1,500

Garage Door Hinge Replacement

Cracked or loose hinges replaced so panels stay aligned and quiet.

Typical $100-$250

Hörmann Garage Door Opener Repair

Openers that hum, click, reverse or won't respond, diagnosed and repaired.

Typical $125-$350

Raynor Garage Door Sensor Repair

Photo-eye sensors realigned, rewired or replaced so the door closes reliably.

Typical $100-$250

DBCI Roll-Up Door Repair

DBCI makes roll-up doors and hallway systems for self-storage.

Typical $150-$600

Overhead Door Garage Door Opener Installation

Overhead Door-brand openers come from the same company as Genie, the Overhead Door Corporation.

Typical $350-$800

Raynor Garage Door Roller Replacement

Raynor, based in Dixon, Illinois, makes residential and commercial garage doors as well as openers.

Typical $150-$350

McKeon Door Rolling Fire Door Inspection & Drop Testing

McKeon makes rolling fire doors, fire curtains and rolling steel doors.

Typical $150-$500

Holmes Garage Door Garage Door Installation

New steel, insulated, wood-look and carriage-style doors, measured and professionally installed.

Typical $1,200-$4,500

Raynor Garage Door Panel Replacement

Raynor, based in Dixon, Illinois, makes residential and commercial garage doors as well as openers.

Typical $300-$900

Overhead Door Rolling Fire Door Inspection & Drop Testing

Annual drop testing and inspection of rolling fire doors.

Typical $150-$500

Clopay Garage Door Panel Replacement

Clopay is one of the largest residential garage door makers in North America, with lines such as Classic, Modern Steel, Coachman and Canyon Ridge. The model is usually printed on a label on the door's end stile, which helps us match replacement panels.

Typical $300-$900

Garage door stuck, noisy or broken?

Talk to a garage door technician in New Hampshire now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote